After the controller of the solar garden light is installed, what aspects should be tested?

In general, connect the positive wire and the load wire first, and then wrap it with tape to prevent it from touching the wires. After the load is connected, connect the battery again, and wrap it with the same tape. Next, don't rush to connect the remaining solar negative wires, and observe whether the working status of the solar garden light controller is normal. After the system is powered on, the red light of the controller flashes a few times to confirm the system. After the system is confirmed, the red light is always on. , After about 20S or 1 minute, the load working indicator lights up, and the load will light up and work. When installing a controller in one of the solar garden lights, the user must first determine whether the controller meets your needs. The common specifications that need to be confirmed are as follows: 1. The operating voltage of the controller is generally 12/24V automatic Identification; 2. Whether the rated current meets the system requirements, such as 5A or 10A; 3. Whether the load output function satisfies, such as a step-down, boost or non-constant current drive type, if the function is incorrect, the load will not work normally. Some accessories may even be damaged. For details, visit: www.chz-lighting.com.