Steps to install solar street lights

1. Put the battery in the battery box first, take the lead out of the box, then fix the screws around the box, pay attention to the sealing of the rubber strip, and then clamp the lead tube with the buckle and the outgoing wire of the stupid body. Bury the box next to the foundation, lead the lead pipe and lead out the conduit in the middle of the foundation, and fill in the soil. This link must be done well. If the battery box does not leak in the next period, it must be sealed and the filling of the soil must be standardized. The box is broken.

2. Install the light source of the lamp, connect the wire (the length of the wire is the length from the bracket to the pole wiring door), and pay attention to the positive and negative poles of the wire when wiring.

3. Fix the battery board and the battery board bracket with screws, and connect the wires (the length of the wire is the length from the bracket to the pole wiring door), and pay attention to the polarity of the wires when wiring.

Four. Fix the lamp bracket and the solar panel bracket, fix the battery panel and the lamp on the bracket, and then use the corresponding crane to start hoisting.

Fifth, adjust the solar panels to the south to ensure maximum power generation.

6. Start wiring. The order of wiring is to connect the battery first, then the light source, and finally the solar panel.

7. Adjust the working mode of the controller (set working time)