Solar street lamp manufacturers talk about the precautions when installing lighting equipment

　　 The installation of solar street lights can be said to be very simple or very complicated. Today, Changhui solar street light manufacturer will give you a brief introduction to the preparation work and precautions before installation of solar street lights. In order to ensure the completion of the solar street light project: 　　 1. Comprehensively understand the characteristics of solar street light lamps, light sources, and poles, and then according to the actual and reference lighting standards of the road, combined with the investment budget, rationally select the various equipment of the solar street light to fully Give full play to the advantages of the high-efficiency and energy-saving effect of the light source, the light distribution and the combination of various accessories; 　　2, under the conditions of guaranteed solar light performance, appropriately increase the spacing between solar street lamps and lamps, thereby saving the number of lamps used, and appropriately increasing the solar energy The height of the street lamp pole to improve the lighting effect; 　　3. According to the actual geological conditions of the solar street lamp project site, design and manufacture the foundation of the solar street lamp pole to ensure the firmness and reliability of the foundation. Pay special attention to the pre-embedded bolts and the reserved holes of the pole seat. The distribution and positioning are accurate, the embedded length and the external length are reasonable, and the threaded part should be properly protected to facilitate hoisting and positioning; 　　4. In the rock formation or weathered stone section, it is difficult to meet the actual requirements for scattered grounding and segmented grounding, so you can consider According to the design requirements, the galvanized flat steel and other conductors should be connected in a long way. The connection should be reliable. At the same time, reasonable and appropriate protective treatments should be added. The embedded foundation should be reliably connected to ensure that each light pole is reliably connected to the ground. The middle and high pole lights of the street lights are scattered and mainly rely on the foundation for grounding. When necessary, a resistance reducing agent is needed to reduce the grounding resistance; 　　 5. Hoisting operations must strictly abide by the operating rules and procedures, and pay special attention to the power grid lines and other lines around the hoisting equipment. As for surrounding structures, the lifting points should be selected reasonably during hoisting, and should be adjusted in time after positioning.