LED solar street light factory analyzes the rainproof problem of solar street light

The led solar street light factory uses a photoelectric intelligent solar controller with charge and discharge protection function, photosensitive automatic control device and time control device, so that the product can effectively save energy, increase effective lighting time, and reduce production costs;

3. After the area is used, the time difference between startup and shutdown is very small, which better overcomes the disadvantages of traditional solar street lights due to excessive startup time difference. In this way, solar street lights are not only suitable for areas rich in solar energy resources, but also suitable for Areas with abundant solar energy resources and areas where solar energy can be utilized. In these areas, solar energy can be used not only for lighting in urban residential areas, high-end residential areas, villas in gardens, public green spaces, city squares, and roads, but also for household lighting in remote villages where conventional energy sources are scarce and it is difficult to generate electricity with conventional energy sources. and ambient lighting.

4. The technical characteristics of solar garden lights are similar to those of solar street lights, only the shape is different.

A practical comparison of the effects of solar street lights and the use of mains lighting fixtures The installation of mains lighting fixtures is complicated: the solar street light factory has complex operating procedures in the mains lighting fixture project. First of all, cables must be laid, and cable trenches must be excavated here. , laying hidden pipes, pipe threading, backfilling and many other basic works. Then carry out long-term installation and debugging, if any line has problems, it will need to be reworked in a large area. In addition, the terrain and route requirements are complex, and labor and auxiliary materials are expensive.

Simple installation of solar street lights: When installing solar street lights, there is no need to lay complicated lines, just make a cement base and fix it with stainless steel screws. Compared with the high electricity cost of the second mains lighting fixtures: the solar street light factory has a fixed high electricity cost, and it is necessary to maintain or replace the lines and other configurations for a long time without interruption, and the maintenance cost is increasing year by year. Free electricity for solar lighting fixtures: Solar lighting fixtures are a one-time investment, without any maintenance cost, the investment cost can be recovered in three years, and long-term benefits. Comparing the three mains lighting with potential safety hazards: the mains lighting has brought many hidden dangers in terms of construction quality, landscape engineering renovation, material aging, abnormal power supply, and conflicts in water and electricity pipelines.

Rainproof problem of solar street lights

The main phenomenon is that the charge and discharge controller is exposed to drenching and moisture, which causes the circuit board to short-circuit and burn out the control device (transistor), which seriously causes the circuit board to be corroded and deteriorated, which cannot be repaired. There are two main ways to enter the water: one is to enter the light pole from the reserved hole at the top of the light pole along the solar cell assembly and the light source lead; the other is to immerse from the gap of the light pole warehouse door; plus the temperature in the warehouse is relatively high , resulting in high humidity in the warehouse, resulting in damage to the controller. Therefore, it is also important to protect the controller from rain and avoid moisture and damage to the controller.